[. . . ] *9000281548* 901202 9000281548 901202 Ú Installation instructions '. %2 PLQ $ PLQ PLQ PLQ PLQ PLQ PLQ $ D PLQ E F PD[ G H % PLQ PLQ D 9 / 1 E PLQ PLQ Ú en I ns tallation instructions Important notes If the appliance is being installed under a hob, refer to the assembly instructions for the hob. The appliance must be disconnected from the power supply during all installation work. Connecting the appliance to the power supply Only a licensed expert may connect the appliance. [. . . ] The service cable must be long enough. Preparing the kitchen units Safe use of this appliance can only be guaranteed if it has been installed professionally in accordance with these installation instructions. The installer is liable for damages incurred as a result of incorrect installation. Units into which ovens are to be fitted must be heat-resistant up to 90 °C and adjacent cabinets up to 70 °C. Carry out all cut-out work on the furniture unit and worktop before fitting the appliances. Otherwise, the correct operation of electrical components may be adversely affected. Secure freestanding units to the wall using standard, commercially available brackets A. 1 To ventilate the appliance, there must be a gap of 20 mm between all intermediate floors and the wall. Only fit the appliance up to a height which allows accessories to be easily removed. Before installation, remove the mounting angles from the rear panel of the appliance. Appliance underneath a worktop without furniture units Figure 2 The gap between the worktop and the appliance must not be closed using additional battens. Screw on the mounting angles and support rails flush with the furniture unit. Corner installation - Figure 3 For corner installation, check minimum clearances. [. . . ] If fitted in a tall unit, screw the appliance in place using the wood screws provided in the cooking compartment Figure 5a. If fitted underneath a worktop, screw the appliance in place using the metal screws provided in the bag - Figure 5b. Removal 1. [. . . ]